Murville soil series

What this means

What Murville soil means for gardens, lawns and septic systems

For gardens

Typical topsoil in Murville soils is very strongly acidic: pH 4.5. Most vegetables and lawn grasses do best around 6.0 to 7.0, so lime is often needed; blueberries, azaleas and rhododendrons like it as it is.

Sandy topsoil covers 100% of mapped Murville acres. It drains fast and warms early in spring, but dries out and loses nutrients quickly: mulch, compost and steady watering help. The most common surface texture is mucky fine sand (61% of mapped Murville acres).

100% of mapped Murville acres is somewhat poorly to very poorly drained, so soil stays soggy for long spells after rain and in wet seasons. Raised beds, plants that tolerate wet feet, and not working the soil while wet all help.

For lawns and yards

On 100% of mapped acres, rain soaks in slowly (hydrologic groups C and D, including dual groups that are D until drained). Expect runoff and puddles after heavy rain: core-aerate compacted lawns and keep ground sloping away from foundations.

A seasonal high water table comes within 18 inches of the surface on 100% of mapped acres, often in spring. Basements, sump pumps and lawns in low spots feel it first.

For a septic system

For conventional septic absorption fields, NRCS rates 100% of the acres in mapped Murville soils very limited, 0% somewhat limited and 0% not limited.

Where the soil is very limited (slow permeability, a high water table, flooding, shallow bedrock or steep slopes), alternative systems such as mound or sand-filter designs are common and cost more.

Flooding is mapped on 61% of the acres (0% occasional, 0% frequent).

Only a licensed site evaluation or perc test at the actual lot decides whether a system is allowed and which design.

Generated from the mapped numbers above using fixed rules, not a site visit. See how these notes are written.